Como Programar Descalcificador Cillit Data Instant

// 4. Check if it's time to regenerate (if scheduled and within time window) if (regeneration_pending && current_hour == regeneration_time_hour) execute_regeneration_cycle(); regeneration_pending = false; total_flow_m3 = 0.0; // reset consumption meter

// Step 2: Brine draw (pull salt water from brine tank) move_valve_to(BRINE_DRAW); delay_minutes(60); // typical Cillit: 45-90 min depending on model

def calculate_remaining_capacity(): # Remaining softening capacity (liters) # capacity_total = resin volume (L) * exchange capacity (eq/L) / hardness (eq/L) available_capacity_liters = capacity_total / hardness_raw como programar descalcificador cillit data

void save_installer_settings() eeprom_write(ADDR_HARDNESS, new_hardness); eeprom_write(ADDR_PERSONS, new_persons); // Recalculate capacity_total based on persons and hardness capacity_total = new_persons * 70 * new_hardness; // 70L/person/day estimate

void check_faults() if (flow_rate_lpm > 0 && hall_sensor_pulses == 0) display_error("E1 – Flow meter stuck"); if (brine_tank_empty_sensor == HIGH) display_error("E2 – Salt low"); trigger_led_flash(RED); if (motor_current > 1.5A) display_error("E3 – Valve jammed"); stop_motor(); regeneration_pending = false

// Step 3: Slow rinse (displace brine) move_valve_to(SLOW_RINSE); delay_minutes(15);

enum ValvePosition SERVICE, BACKWASH, BRINE_DRAW, SLOW_RINSE, FAST_RINSE, BRINE_REFILL ; void execute_regeneration_cycle() // Step 1: Backwash (reverse flow to clean resin) move_valve_to(BACKWASH); delay_minutes(10); total_flow_m3 = 0.0

// 3. Decide if regeneration needed if ( (capacity_total - consumed) < (capacity_total * 0.15) ) // less than 15% capacity left schedule_regeneration();